Want to Pass 400-101 Exam In Next HOURS? Get it now →
January 8, 2019

The Only Tip You Need: ccie 400 101

Master the 400 101 pdf CCIE Routing and Switching (v5.0) content and be ready for exam day success quickly with this Actualtests 400 101 ccie test preparation. We guarantee it!We make it a reality and give you real 400 101 dumps questions in our Cisco ccie 400 101 braindumps.Latest 100% VALID Cisco cisco 400 101 Exam Questions Dumps at below page. You can use our Cisco passleader 400 101 braindumps and pass your exam.

P.S. Real 400-101 pack are available on Google Drive, GET MORE: https://drive.google.com/open?id=1w17YlOA_j6Gfs1iI5gb9qcK0Elb9hzTn


New Cisco 400-101 Exam Dumps Collection (Question 16 - Question 22)

New Questions 16

Refer to the exhibit.

You have configured a VRF named Blue on R1 as shown. Which action must you take to enable uRPF on the R1 interface E1/0?

A. Configure the ip verify Blue unicast source reachable-via rx allow-default command on interface E0/1

B. Configure the ip verify Blue unicast source reachable-via rx allow-default command under the VRF Blue process

C. Configure the ip verify unicast source reachable-via rx allow-default command under the VRF Blue process

D. Configure the ip verify vrf Blue unicast source reachable-via rx allow-default command on interface E0/1

E. Configure the ip verify unicast source reachable-via rx allow-default command on interface E1/0

Answer: E



New Questions 17

Refer to the exhibit.

Which configuration must you apply to a router so that it can generate a log message in this format?

A. Service timestamps log datetime localtime show-timezone Service sequence-numbers

B. Service timestamps log datetime msec localtime Service sequence-numbers

C. Service timestamps log datetime msec localtime show-timezone Service sequence-numbers

D. Service timestamps log datetime msec localtime show-timezone Service linenumber

E. Service timestamps log datetime msec localtime show-timezone Service alignment logging

Answer: C



New Questions 18

R1#showip ospfinterface FastEthernet0/0.12

...Network Type Non_BROADCAST...

...

R2#showip ospfinterface FastEthernet0/0.12

...Network Type

BROADCAST...

...

Refer to the exhibit. OSPF is configured on R1 and R2 as shown. which action can you take to allow a

neighbor relationship to be established.

A. On R1, change the process ID to 1

B. On R1, set the network type of the FastEthernet0/0.12 interface to broadcast

C. Configure R1 and R2 as neighbors using interface addresses

D. Configure R1 and R2 as neighbors using router IDs

Answer: B



New Questions 19

which type of IPv6 address is 2001:DB8::FFFF:FFFF/32?

A. multicast address

B. host address

C. broadcast address

D. anycast address

Answer: B



New Questions 20

which condition must be true to allow an access port to trust QoS markings on an incoming frame?

A. The switch must be configured globally with the vlan dot1q tag native command

B. The switch must be configured globally with the mls qos trust cos command

C. The port must be configured with the mls qos trust dscp command

D. The port must be configured with the mls qos cos command

Answer: C



New Questions 21

Refer the exhibit.

What are two effects of the given configuration? (Choose two)

A. Sources for the 239.1.1.1 multicast stream will register with 172.1.1.1.

B. Multicast stream 244.1.1.1 will operate in sparse mode.

C. Multicast stream 244.1.1.1 will operate in dense mode.

D. It configures 172.1.1.1 as the Bidir u2013 PIM rendezvous point.

E. Sources for the 224.1.1.1 multicast stream will register with 172.1.1.1.

F. It configures 172.1.1.1 as a sparse-mode rendezvous point.

Answer: A,D



New Questions 22

Which feature can mitigate hung management sessions?

A. Contru00f6l Plane Policing

B. the service tcp-keepalives-in and service tcp-keepalives-out commands

C. the servicu00ea tcp-small servers command

D. vty line ACLs

Answer: B




see more http://www.ubraindumps.com/400-101-dumps/

100% Latest Cisco 400-101 Questions & Answers shared by Examcollection, Get HERE: http://www.examcollectionuk.com/400-101-vce-download.html (New 427 Q&As)